Bone Graft

The purpose of this research is to provide comparative data about the Avitus product and its equivalence to other Bone Marrow Aspirate (BMA) harvesting techniques.

Guided bone regeneration (GBR) is a procedure used to increase the amount of bone volume in the jaw before placing a dental implant. It is needed when a lot of bone has been lost around the spot where a tooth has been lost or extracted. An incision is made, bone grafting material is placed in that spot, there is a membrane put over it as a barrier, then gum tissue has to be pulled back over it. Usually, this is enough to cover the whole wound, but sometimes the barrier membrane can't be covered with tissue the whole way without too much pulling, and the barrier membrane is still exposed. In that case, one thing that can be done is to place another material, an acellular collagen matrix, over the barrier membrane and secure it there. This material has been shown to help with the healing in these cases. Participants in this study will be clinic patients who have been determined to need a GBR procedure. Participants will get the GBR. If the barrier membrane is still exposed, then the acellular matrix material will be placed. This study will compare the healing outcomes and the success of the GBR depending on whether the acellular matrix material was used. The procedure itself is not part of the study. The only people in the study are patients who are already planning to have this procedure done as part of their dental care. It is important to note that the research study will not affect the care that the patient is given, or whether or not the acellular matrix material is used. That will be decided by the dental surgeon who is treating them, based on their clinical judgement. The research study will only observe and compare the outcomes. For the study, participants will have some additional clinical measurements made, besides the ones that are done as part of the follow-up care, and will be asked questions about their experience.

The purpose of the study is to compare a new grafting material for alveolar ridge preservation to a commonly used and well studied material. Alveolar ridge dimensions as well as histology will be compared.

The objective of this study is to evaluate the safety and performance of AdvanCore implantable bone graft through a 12-month follow-up period in a prospective, parallel-group design, non-controlled, open label, multi-center and real-world setting study. This study is intended to satisfy post-market clinical follow-up requirements of CE Mark in Europe.

Adult spinal deformity surgery is a complex procedure that involves many risks and complications. Bone grafts and bone substitutes are essential to achieve fusion and manage stability in spinal surgery. Autologous bone has been considered the "gold-standard" for obtaining a spinal fusion. However, the source from which to obtain it is limited. Furthermore, the problems of bone quality in patients with osteoporosis and the morbidity have forced the orthopedic community to seek other options. I-Factor ™ Bone Graft (Cerapedics, Inc., Westminster, CO) is a compound formed by peptide P-15 bound to an anorganic bone mineral of bovine origin that is composed of porous and smooth hydroxyapatite (ABM) particles. In the literature there are no articles which identify bone formation with the i-Factor ™ graft in more than 4 instrumented levels, therefore the development of this study will allow assessing the fusion rate and quality of life of patients, which could lead to an improvement in the management and decision-making of surgical procedures, as well as better control of healthcare spending